I just can't get the hang of interfacing the Insteon plug-in with X10.
I have an old 3-speed X10 fan switch in the bedroom. (Yes, someday it will be a FanLinc, but not now). It is addressed as A2. So in HomeSeer (because we don't define X10 devices in the Plug-In, right?) I created the device Ceiling Fan and under the Configuration tab I put A2 as the Code. Then under the Insteon Tab I made it Dimmable. (I've tried Not Dimmable, too, with no change in results).
Then I defined a button on my RemoteLinc as Ceiling Fan, and left it as "Local control reporting to HomeSeer".
I then defined an Event:
If Remote Button 2 Transmits an ON command <--see, I learned about Insteon Special Commands!
THEN
Set Device First Floor Master Bedroom Ceiling Fan to ON
It doesn't work. What am I missing? :confused:
By the way, is there a doc file, a tutorial, or even a Sticky post on this? A step-by-step would be very helpful.
Thanks.
I have an old 3-speed X10 fan switch in the bedroom. (Yes, someday it will be a FanLinc, but not now). It is addressed as A2. So in HomeSeer (because we don't define X10 devices in the Plug-In, right?) I created the device Ceiling Fan and under the Configuration tab I put A2 as the Code. Then under the Insteon Tab I made it Dimmable. (I've tried Not Dimmable, too, with no change in results).
Then I defined a button on my RemoteLinc as Ceiling Fan, and left it as "Local control reporting to HomeSeer".
I then defined an Event:
If Remote Button 2 Transmits an ON command <--see, I learned about Insteon Special Commands!
THEN
Set Device First Floor Master Bedroom Ceiling Fan to ON
It doesn't work. What am I missing? :confused:
By the way, is there a doc file, a tutorial, or even a Sticky post on this? A step-by-step would be very helpful.
Thanks.