Has anyone experienced issues with the Elk M1 Plug-in over the past week?
I use Elk outputs to signal certain conditions with Elk devices. For instance I Have output 20 go high when any Fire alarm activates. What I am seeing is output 20 go high on the Elk side but no change on the Homeseer side plug-in. I have also tried this with zone conditions being violated and then back to normal with no change on the Homeseer side.
It has been awhile since I visited the plug-in but some things seem different like the plug-in automatically puts check marks for Elk devices and they are all grayed out. I did an update and got this message (Install/Update of package UltraM1G3 (Elk M1 Plug-in) failed.) but after a refresh it went away. I have reinstated the plug-in several times and restarted the controller many times.
The plug-in status is ok and connected
Any help would be appreciated.
Bob
I use Elk outputs to signal certain conditions with Elk devices. For instance I Have output 20 go high when any Fire alarm activates. What I am seeing is output 20 go high on the Elk side but no change on the Homeseer side plug-in. I have also tried this with zone conditions being violated and then back to normal with no change on the Homeseer side.
It has been awhile since I visited the plug-in but some things seem different like the plug-in automatically puts check marks for Elk devices and they are all grayed out. I did an update and got this message (Install/Update of package UltraM1G3 (Elk M1 Plug-in) failed.) but after a refresh it went away. I have reinstated the plug-in several times and restarted the controller many times.
The plug-in status is ok and connected
Any help would be appreciated.
Bob