Guys, quick thing to get me on track here as my old HV died.
I have an ADIO all connected and seems just fine but I'm clearly being dim since I cannot figure out how the old PIRs connected to HV are connected to the ADIO.
They are standard 12V affairs with a ground and signal for the trigger on the PIRs, all bar one are the same deal.
What I have is a 12V supply on a ring in effect that powers all the PIRs.
Then I had a common ground on the old HV for them all in each bank of ports so, eight PIRs would equate to eight grounds on the same terminal.
Then the signal on each port for each individual PIR.
The question is, to replicate that in HS using the ADIO how is it best to connect them up and get HV to see the changes on the ports?
Thanks
K.
I have an ADIO all connected and seems just fine but I'm clearly being dim since I cannot figure out how the old PIRs connected to HV are connected to the ADIO.
They are standard 12V affairs with a ground and signal for the trigger on the PIRs, all bar one are the same deal.
What I have is a 12V supply on a ring in effect that powers all the PIRs.
Then I had a common ground on the old HV for them all in each bank of ports so, eight PIRs would equate to eight grounds on the same terminal.
Then the signal on each port for each individual PIR.
The question is, to replicate that in HS using the ADIO how is it best to connect them up and get HV to see the changes on the ports?
Thanks
K.