.90 Battery not working for Zooz yet

Have a Zooz and was excited to see .90 was going to fix battery display... Installed without a hitch but still no battery. Did a drive by to wake up the unit and the "detect motion" is working but still no battery.

I also noticed that now I am getting an unknown CC.



Aug-19 22:37:42 Z-Wave ApplicationCommandHandler from node 4 HANDLING: COMMAND_CLASS_SECURITY Frame(7)=129
Aug-19 22:37:42 Z-Wave Device: 2 Family Room Home Security Set to NOTIFICATION for type Home Security, Event: Motion Detected Unknown Location
Aug-19 22:37:42 Z-Wave ApplicationCommandHandler from node 4 HANDLING: COMMAND_CLASS_ALARM_V2 Frame(7)=5
Aug-19 22:37:42 Z-Wave ApplicationCommandHandler from node 4 HANDLING: COMMAND_CLASS_SECURITY Frame(7)=129
Aug-19 22:37:42 Z-Wave Z-NET-FLOOR3: Sending to node 4 (Undefined) CC=COMMAND_CLASS_SECURITY
Aug-19 22:37:42 Z-Wave ApplicationCommandHandler from node 4 HANDLING: COMMAND_CLASS_SECURITY Frame(7)=64
Aug-19 22:37:42 Z-Wave ApplicationCommandHandler from node 4 HANDLING: COMMAND_CLASS_BASIC Frame(7)=1
Aug-19 22:37:42 Z-Wave ApplicationCommandHandler from node 4 HANDLING: COMMAND_CLASS_SECURITY Frame(7)=129
Aug-19 22:37:42 Z-Wave Z-NET-FLOOR3: Sending to node 4 (Undefined) CC=COMMAND_CLASS_SECURITY
Aug-19 22:37:42 Z-Wave ApplicationCommandHandler from node 4 HANDLING: COMMAND_CLASS_SECURITY Frame(7)=64

Also now getting the following error:

Aug-18 18:18:54 Z-Wave Warning Z-NET-FLOOR3 : Secure message received from node 4. It was successfully decrypted but the data sequence ID is out of sequence. (Not Processed)

Attached Images