Yesterday, I had to replace a bad node (Aeon Labs slave repeater), so I used the replace node procedure. It was replaced successfully, but now a couple of devices are not showing the root device correctly.
The root devices have question marks now. The Re-scan, Remove, and Replace buttons on the Z-wave tab are showing as question marks, and Settings/Association drop-downs are grayed out.
I went to controller properties and re-imported and did a full scan, rebooted the server, etc., but it still won't show the settings. The meter is working fine, btw.
Similarly, if I hit audit node, I get this:
Could not find Parent for Z-Wave device passed to the Audit function.
How can I restore this?
The root devices have question marks now. The Re-scan, Remove, and Replace buttons on the Z-wave tab are showing as question marks, and Settings/Association drop-downs are grayed out.
I went to controller properties and re-imported and did a full scan, rebooted the server, etc., but it still won't show the settings. The meter is working fine, btw.
Similarly, if I hit audit node, I get this:
Could not find Parent for Z-Wave device passed to the Audit function.
How can I restore this?