Hi Guys,
Trying to tidy up a few things in my network, and went to configure some of my AEON LABS micro motor controllers. After selecting the settings tab the plugin effectively crashes and I'm unable to do anything. The zwave tab of the device is cleared of everything, effectively leaving it blank.
I can audit the node, scan the node, successfully test connectivity & it functions as it should. Just Can't get the config. screen to successfully appear.
The log shows the errors in the attached.
This doesn't happen on all devices, just seems to be the motor controllers.
Has anybody got any ideas where to start? I've tried all the usual things, restarting HS etc. etc.
Any thoughts would be appreciated,
Thanks in advance Steve.
Trying to tidy up a few things in my network, and went to configure some of my AEON LABS micro motor controllers. After selecting the settings tab the plugin effectively crashes and I'm unable to do anything. The zwave tab of the device is cleared of everything, effectively leaving it blank.
I can audit the node, scan the node, successfully test connectivity & it functions as it should. Just Can't get the config. screen to successfully appear.
The log shows the errors in the attached.
This doesn't happen on all devices, just seems to be the motor controllers.
Has anybody got any ideas where to start? I've tried all the usual things, restarting HS etc. etc.
Any thoughts would be appreciated,
Thanks in advance Steve.