I just installed a clamp on energy meter. It paired ok, using the HomeSeer Ztool app. That was nice.
When I checked for power, the device showed nothing. 0 Watts and 0 Power. So obviously I thought I installed it wrong or it was broke.
Since it came with a power supply I used that and didn't put in batteries. The instructions are terrible.
Anyway I decided to Poll the device and it got the reading ok. Then I stopped the power and it never updated. I had to Poll again. I waited like an hour to see if it would update by itself.
I'm hoping there is a way to get it to update by itself. I'm running the latest zwave plugin. Just installed it.
Any ideas?
When I checked for power, the device showed nothing. 0 Watts and 0 Power. So obviously I thought I installed it wrong or it was broke.
Since it came with a power supply I used that and didn't put in batteries. The instructions are terrible.
Anyway I decided to Poll the device and it got the reading ok. Then I stopped the power and it never updated. I had to Poll again. I waited like an hour to see if it would update by itself.
I'm hoping there is a way to get it to update by itself. I'm running the latest zwave plugin. Just installed it.
Any ideas?
