I can't seem to find anything other than the install guide and I have a few questions:
1) I assume the HDMI port is for a monitor and the USBs could be used for a keyboard. What's the little round connector (looks like it could be power) on the side?
2) The WiFi isn't documented well, but I'm guessing that's to access a WAP when moving the Z-Net close to a legacy device for inclusion. Is it common to configure BOTH wired and wireless access? Or do you switch before disconnecting from a network cable?
3) How do you provide power to the Z-Net when moving it? Extension cord to the supplied wall wart? Damn, that's a lot less elegant than a Z-Troller.
4) How do you include a device when Z-Net has been moved to device? No buttons or anything on the Z-Net makes me think using the UI in HS3. I suppose I can do that from (for instance) a laptop near the device being included.
5) What's the point of the USB ports other than as I/O when booting the Z-Net?
If there's any kind of documentation of this stuff please point me...
1) I assume the HDMI port is for a monitor and the USBs could be used for a keyboard. What's the little round connector (looks like it could be power) on the side?
2) The WiFi isn't documented well, but I'm guessing that's to access a WAP when moving the Z-Net close to a legacy device for inclusion. Is it common to configure BOTH wired and wireless access? Or do you switch before disconnecting from a network cable?
3) How do you provide power to the Z-Net when moving it? Extension cord to the supplied wall wart? Damn, that's a lot less elegant than a Z-Troller.
4) How do you include a device when Z-Net has been moved to device? No buttons or anything on the Z-Net makes me think using the UI in HS3. I suppose I can do that from (for instance) a laptop near the device being included.
5) What's the point of the USB ports other than as I/O when booting the Z-Net?
If there's any kind of documentation of this stuff please point me...