Upgraded from HS2 to HS3 and I cannot get the CM15A plugin to work (it's working fine in HS2)
On the Installed Plug-In page it tells me the plug-in status for CM15A is OK. The com port states N/A (though it should be visible on a COM port right??)
There's no X10 tab to be found anywhere and when I try to switch on/off an X10 device nothing happens either.
Tried to use the CM11A (on COM1 for me) instead .. but that's not working either .. (**FATAL**: Unable to communicate with CM11A, no response to status request) (CM15A plugin is disabled when I try this)
On the Installed Plug-In page it tells me the plug-in status for CM15A is OK. The com port states N/A (though it should be visible on a COM port right??)
There's no X10 tab to be found anywhere and when I try to switch on/off an X10 device nothing happens either.
Tried to use the CM11A (on COM1 for me) instead .. but that's not working either .. (**FATAL**: Unable to communicate with CM11A, no response to status request) (CM15A plugin is disabled when I try this)