I'm just trying Homeseer to see if it works in my house and it's not going as well as I would have hope. I'm getting very poor network range (less than 9 metres between nodes) and strange optimization reports. I've ran optimization a few times and also tried full optimation but get the report shown below. How is it possible that nodes 4 and 6 both have node 7 as a neighbor but node 7 only reports node 4 as a neighbor (node 6 is in the room below node so about 4 metres away)? I'm using a z-wave.me UZB interface if that's relevant.
![]()
↧