DS10 with current sensor Active Zone

I am monitoring the power state of TVs, Amplifiers, & a steam generator with an DS10. DS10 is connected to a current sensor. I have added the DS10 to BLRF and then to BLRADAR. Each one is part of an active zone. I can get the RLRADAR to reflect the state by changing the text:
.

Appliance is ON the DS = ALERT; when OFF = NORMAL.

That is not really helping, however. When the appliance is ON (ALERT), I would like the Active Zone to remain Active.

In DooMotion I reversed the Value Triggered Device Options. What values can I use?



Any ideas?